J. Lin, Review of research on low-profile vortex generators to control boundary-layer separation, Prog Aerosp Sci, vol.38, pp.389-420, 2002.

M. R. Islam, M. A. Hossain, M. Mashud, and M. Tanvir, Drag reduction of a car by using vortex generator, Int J Sci Eng Res, vol.4, issue.7, 2013.

A. Ghanem, T. Lemenand, D. Valle, D. Peerhossaini, and H. , Static mixers: mechanisms, applications, and characterization methods e a review, Chem Eng Res Des, vol.92, issue.2, pp.205-233, 2014.

M. Hatami, D. Ganji, and M. Gorji-bandpy, Experimental investigations of diesel exhaust exergy recovery using delta winglet vortex generator heat exchanger, Int J Therm Sci, vol.93, pp.52-63, 2015.

G. Biswas, K. Torii, D. Fujii, and K. Nishino, Numerical and experimental determination of flow structure and heat transfer effects of longitudinal vortices in a channel flow, Int J Heat Mass Transf, vol.39, issue.16, pp.3441-51, 1996.

R. Webb and N. Kim, Principles of enhanced heat transfer, 1994.

S. W. Chang, A. W. Lees, and H. Chang, Influence of spiky twisted tape insert on thermal fluid performances of tubular airewater bubbly flow, Int J Therm Sci, vol.48, pp.2341-54, 2009.

H. Gül and D. Evin, Heat transfer enhancement in circular tubes using helical swirl generator insert at the entrance, Int J Therm Sci, vol.46, pp.1297-303, 2007.

M. A. Elyyan and D. K. Tafti, A novel split-dimple interrupted fin configuration for heat transfer augmentation, Int J Heat Mass Transf, vol.52, pp.1561-72, 2009.

C. Habchi, S. Russeil, D. Bougeard, J. L. Harion, T. Lemenand et al., Enhancing heat transfer in vortex generator-type multifunctional heat exchangers, Appl Therm Eng, vol.38, pp.14-25, 2012.

J. Tala, S. Russeil, D. Bougeard, and J. Harion, Numerical analysis of the fin spacing effect on the horseshoe vortex system evolution in a two-rows finned-tube heat exchanger, Int J Numer Methods Heat Fluid Flow, vol.23, issue.7, pp.1136-54, 2013.

S. Vintrou, D. Bougeard, S. Russeil, R. Nacereddine, and J. Harion, Quantitative infrared investigation of local heat transfer in a circular finned tube heat exchanger assembly, Int J Heat Fluid Flow, vol.104, 2013.

A. Garcia, J. Solano, P. Vicente, and A. Viedma, The influence of artificial roughness shape on heat transfer enhancement: corrugate tubes, dimpled tubes and wire coils, Appl Therm Eng, vol.35, 2012.

J. Wang and Y. Zhao, Heat and fluid flow characteristics of a rectangular channel with a small diameter circular cylinder as vortex generator, Int J Therm Sci, vol.92, pp.1-13, 2015.

C. Habchi, T. Lemenand, D. Valle, D. Peerhossaini, and H. , Turbulence behavior of artificially generated vorticity, J Turbul, vol.11, issue.36, pp.1-28, 2010.

M. Khoshvaght-aliabadi, S. Zangouei, and F. Hormozi, Performance of a plate-fin heat exchanger with vortex-generator channels: 3D-CFD simulation and experimental validation, Int J Therm Sci, vol.88, pp.180-92, 2015.

J. Wu and W. Tao, Numerical study on laminar convection heat transfer in a channel with longitudinal vortex generator. Part B: parametric study of major influence factors, Int J Heat Mass Transf, vol.51, pp.3683-92, 2008.

P. Saha, G. Biswas, and S. Sarkar, Comparison of winglet-type vortex generators periodically deployed in a plate-fin heat exchanger e a synergy based analysis, Int J Heat Mass Transf, vol.74, pp.292-305, 2014.

C. Habchi, J. L. Harion, S. Russeil, D. Bougeard, F. Hachem et al., Chaotic mixing by longitudinal vorticity, Chem Eng Sci, vol.104, pp.439-50, 2013.

C. Habchi, T. Lemenand, D. Valle, D. , A. Shaer et al., Experimental study of the flow field behind a perforated vortex generator, J Appl Mech Tech Phys, vol.16, pp.221-230, 2015.

L. Li, X. Du, Y. Zhang, L. Yang, and Y. Yang, Numerical simulation on flow and heat Fig. 10. Vortices developing mechanism for the IPWP at x/H ¼ 2.5, 3, 3.5 and 8 from velocity inlet. transfer of fin-and-tube heat exchanger with longitudinal vortex generators, Int J Therm Sci, vol.92, pp.85-96, 2015.

G. Biswas, N. Mitra, and M. Fiebig, Heat transfer enhancement in fin-tube heat exchangers by winglet type vortex generators, Int J Heat Mass Transf, vol.37, issue.2, pp.283-91, 1994.

P. Deb, G. Biswas, and N. Mitra, Heat transfer and flow structure in laminar and turbulent flows in a rectangular channel with longitudinal vortices, Int J Heat Mass Transf, vol.38, issue.13, pp.2427-2471, 1995.

R. Kamboj, P. S. Dhingra, and P. G. Singh, CFD simulation of heat transfer enhancement by plain and curved winglet type vortex generators with punched holes, Int J Eng Res General Sci, vol.2, issue.4, 2014.

G. Zhou and Z. Feng, Experimental investigations of heat transfer enhancement by plane and curved winglet type vortex generators with punched holes, Int J Therm Sci April, vol.78, pp.26-35, 2014.

J. He, L. Liu, and A. M. Jacobi, Air-side heat-transfer enhancement by a new winglettype vortex generator array in a plain-fin round-tube heat exchanger, J Heat Transf, vol.132, pp.71801-71802, 2010.

Y. He, H. Han, and Y. Tao, Numerical study of heat-transfer enhancement by punched winglet-type vortex generator arrays in fin-and-tube heat exchangers, Int J Heat Mass Transf, vol.55, pp.5449-58, 2012.

J. Wu and W. Q. Tao, Investigation on laminar convection heat transfer in fin-andtube heat exchanger in aligned arrangment with longitudinal vortex generator from the viewpoint of field synergy principle, Appl Therm Eng, vol.27, pp.2609-2626, 2007.

J. Herpe, D. Bougeard, S. Russeil, and M. Stanciu, Numerical investigation of local entropy production rate of a finned oval tube with vortex generators, Int J Therm Sci, vol.48, pp.922-957, 2009.

M. Fiebig, Embedded vortices in internal flow: heat transfer and pressure loss enhancement, Int J Heat Fluid Flow, vol.16, issue.5, pp.376-88, 1995.

S. Tiggelbeck, N. Mitra, and M. Fiebig, Flow structure and heat transfer in a channel with multiple longitudinal vortex generators, Exp Therm Fluid Sci, vol.5, issue.4, pp.425-461, 1992.

A. Ghanem, C. Habchi, T. Lemenand, D. Valle, D. Peerhossaini et al., Energy efficiency in process industry e high-efficiency vortex (HEV) multifunctional heat exchanger, Renew Energy, vol.56, pp.96-104, 2013.

M. Fiebig, Vortex generators for compact heat exchangers, J Enhanc Heat Transf, vol.2, issue.1e2, pp.43-61, 1995.

L. Tian, Y. He, and Y. Lei, Numerical study of fluid flow and heat transfer in a flat plate channel with longitudinal vortex generators by applying field synergy principle analysis, Int Commun Heat Mass Transf, vol.36, issue.2, pp.111-131, 2009.

A. Jain, G. Biswas, and D. Maurya, Winglet-type vortex generators with commonflow-up configuration for fin-tube heat exchangers, Numer Heat Transf Part A, vol.43, pp.201-220, 2003.

I. Ansys, Turbulence models. ANSYS fluent 12.0 theory guide, p.27, 2009.

F. Menter, Two-equation eddy-viscosity turbulence models for engineering applications, AIAA, vol.32, pp.1598-605, 1994.

I. Ansys, Standard and SST k-w models. ANSYS fluent 12.0 theory guide, pp.131-136, 2009.

K. Yongsiri, P. Eiamsa-ard, K. Wongcharee, and S. Eiamsa-ard, Augmented heat transfer in a turbulent channel flow with inclined detached-ribs, Case Stud Therm Eng, vol.3, pp.1-10, 2014.

X. Tanga and D. Zhu, Flow structure and heat transfer in a narrow rectangular channel with different discrete rib arrays, Chem Eng Process Process Intensif, vol.69, pp.1-14, 2013.

R. Warming and R. Beam, Upwind second-order difference schemes and applications in aerodynamic flows, AIAA J, vol.14, issue.9, pp.1241-2149, 1976.

M. Nacer-bey, S. Russeil, and B. Baudoin, PIV visualizations to the flow structure upstream of the tubes in a two-row plate-fin-and-tube heat exchanger, Proceeding of the 4th International conference on compact heat exchangers and enhancement technology for the process Industries

H. Versteeg and W. Mallasekera, Computational fluid Dynamics. London: Longman Group, 1995.

O. Zikanov, Essential computational fluid Dynamics, 2010.

P. Naphon and K. Kornkumjayrit, Numerical analysis on the flow and heat transfer in the channel with V-shaped wavy lower plate, Int Commun Heat Mass Transf, vol.35, pp.839-882, 2008.

A. Bejan and A. Kraus, Heat transfer handbook, vol.1, pp.395-438, 2003.

S. Tiggelbeck, N. K. Mitra, and M. Fiebig, Comparison of wing-type vortex generators for heat transfer enhancement in channel flows, J Heat Transf, vol.116, pp.880-885, 1994.

J. Jeong and F. Hussain, On the identification of a vortex, J Fluid Mech, vol.285, pp.69-94, 1995.